|Ports:||Four Medium Pressure Ports, Two High Pressure Ports||Type:||DIN/INT|
|Material:||Chrome Plated Brass||Weight:||750g/DIN|
|Relative Medium Voltage:||0.9±0.1mpa||Use:||Scuba Diving|
CE Scuba Diving Regulator,
Lightweight Scuba Diving Regulator,
Brass First Stage Scuba Regulator
ZT105 The First Head Of The Diving Regulator Silver Brass Plated Cautery Material
•Made of brass and chrome plated, the balanced diaphragm provides a steady flow of sufficient air irrespective of depth, bottle pressure and respiration rate
|Ports||4 medium voltage ports 3/8 " to 24UNF, 2 high voltage ports 7/16" to 20UNF/rotating medium voltage ports|
|Relative medium pressure||0.9±0.1mpa|
|Model||Balanced diaphragm type|
|Type||DIN/INT is optional|
|Average output flow||≥1000 L/min|
|Weight||750 g /DIN|
(1) Do not assemble the low pressure tube on the high pressure hole of the first level unloader (with HP), nor connect the high pressure tube to the low pressure outlet of the first level unloader.
(2) The two-stage compressor is the medium-pressure air from the low-pressure outlet of the first-stage compressor, and the pressure is 0.95± 0.05mpa.
Select the high pressure pipe and medium pressure pipe to connect the hole.
Turn the high pressure plug and low pressure plug counterclockwise using a hex wrench.
Reserve these high and low pressure plugs for future use.
Base some lubricating oil to end thread of tube and o-ring (silicone oil may also be used, but silicone oil equipment should not be used on high oxygen diving).
Turn the pressure pipe clockwise to the corresponding outlet and use the torque tool to tighten the torque value. The torque value of the tool should be 40in-lbs.
Regulator First stages ZT105